IC676PBO082 VersaMax IP Output Module , China IC676PBO082 VersaMax IP Output Module Manufacturers, Suppliers, Factory

Overview

Place of Origin:	USA
Brand Name:	GE
Model Number:	IC676PBO082
Packaging Details:	Original new Factory Sealed
Delivery Time:	5-7 days
Payment Terms:	T/T
Supply Ability:	In stock

Specifications

Parameter	Value
Module Name	IC676PBO082 VersaMax IP Output Module
Module Type	VersaMax IP Output Module
Housing Dimensions (W x H x D)	60 x 178 x 49.3 mm (2.362 x 7.008 x 1.941 in)
Connection Style	2- or 3-wire
Operating Temperature	-25°C to +60°C (-13°F to +131°F)
Storage Temperature	-25°C to +85°C (-13°F to +185°F)
Operating / Storage Humidity	95% (slight condensation permitted on outer housing, short periods)
Degree of Protection	IP67 (IEC 60529)
Class of Protection	Class 3 (VDE 0106, IEC 60536)
Nominal Voltage	24 VDC
Voltage Range	18–30 VDC
Current Consumption UL @ 24 VDC	40 mA typical, 100 mA maximum
Current Consumption US @ 24 VDC	3 mA typical, 700 mA maximum
Current Consumption UAXX @ 24 VDC	12 mA typical plus actuation
Overload Response	Auto restart
Restart Frequency with Ohmic Overload (2 Ω)	≈ 45 Hz
Inductive Overload Response	Output may be damaged
Reverse Voltage Endurance	Protected against short pulses
Resistance to Permanently Applied Reverse Voltages	No
Response upon Power Down	Output follows supply voltage without delay
Validity of Output Data after Power Up	5 ms typical
Limitation of Demagnetization Voltage Induced on Circuit Interruption	≈ -11 V
Single Maximum Energy in Free Running	1500 W
Protective Circuit Type	Integrated free-wheeling diode per channel
Overcurrent Shutdown	2.6 A maximum
Output Current when Switched Off	20 µA maximum
Output Current with Ground Connection Interrupt when Switched Off	5 mA maximum

Description

The GE IC676PBO082 is a VersaMax IP Output Module, belonging to the GEFanuc PACSystems series. This module is primarily used to convert digital control signals from a PLC into actual control outputs to control external devices such as relays and solenoid valves.

Applications

Manufacturing

Petrochemicals

Energy

Water Treatment

Features

Connection to Profibus-DP using M12 connectors

Baud rates up to 12 Mbaud autobaud

Connection to digital actuators using M12 connectors, each with load capacity up to 2A nominal current

Flexible voltage supply

Diagnostic and status indicators

Short-circuit and overload protection of outputs

IP67 protection

Module Diagnostic Data

The module also provides 12 bytes of diagnostic data to the master, in the format shown below. Of this data, bytes 0 through 6 are Profibus standard data. Bytes 7 through 12 are specific to this module. If a diagnostic event occurs, the module generates a telegram containing the diagnostic data to the master. The module can read the current diagnostic data at any time.

Connection Guidelines

1 Meet Noise Immunity Requirements. Connect FE using a mounting screw, or (when mounting the module on the side or on a non-conductive surface), using a cable connection to the FE connection point.

2 Ensure IP67 Protection. Cover the unused sockets with

protective caps (IC676ACC002 and ACC004).

3 Avoid Polarity Reversal of the supply voltages UL, US and UA.

4 Connect the actuators to the correct points as shown on the next page.