DS200TBQAG1ABB RST Analog Termination Board

Overview

Place of Origin:	USA
Brand Name:	GE
Model Number:	DS200TBQAG1ABB
Packaging Details:	Original new Factory Sealed
Delivery Time:	5-7 days
Payment Terms:	T/T
Supply Ability:	In stock

Specifications

Description

This DS200TBQAG1ABB RST Analog Termination Board was originally manufactured by General Electric for use in their Mark V Turbine Control System Series. The Mark V Series that this DS200TBQAG1ABB PCB belongs to has specific applications in the control and management systems of compatible wind, steam, and gas turbine automated drive assemblies. The Mark V Turbine Control System Series that this DS200TBQAG1ABB RST Analog Termination Board belongs to is also considered one of the final General Electric Mark product series to make use of their patented Speedtronic control system technology, a technology first introduced alongside the rollout of the Mark I Series in the late 1960s.

Applications

Heavy-duty power plants: Equipped with GE Frame 6B, 7E/EA, 9E, and other gas turbine systems.

Petrochemical machinery drives: Used for automated control and management of compressor stations.

Wind/steam power generation: As part of the control and management system.

Replacement

When replacing the board, however, all you have to do is remove the signal wires from the old one and put them in the same terminal on the new one. Because you may have numerous sianal wires to reconnect.vou must be careful to connect them to the correct terminal. Before you beain.make sure you have somebody who are qualified to turn off the drive's power. Installers who are knowledgeable with the drive's installation will be familiar with the power, signal, and ground wiring. An electrician who is familiar with the setup would be qualified to turn off the electricity.

Installation

When you first install the GE RST Terminal Board DS200TBQAG1ABB the written materials that come with the board describe the signal connections that can be made to the terminals. After you understand which terminal to connect a signal wire to, you must strip the insulation off the end of the signal wire to expose roughly 0.5 inch. Then, loosen the screw and insert the wire into the terminal. You can next tighten the screw to secure the wire. Pull the wire gently to check that it is installed in the terminal and cannot easily be removed. However, when you replace the board you only must remove the signal wires from the old board and reinstall them in the same terminal in the replacement board. Because you potentially have multiple signal wires to reattach, care must be taken to ensure you attach them to the right terminal. Before you start, check with individuals that are qualified to remove power to the drive. Installers that are familiar with the installation of the drive will understand the power cabling, signal cabling, and ground wiring. An electrician familiar with the installation would also be qualified to remove the power. Some capacitors on the boards in the drive retain power after the power is removed from the drive. However, after 30 seconds the power exits the capacitors and other components and the board is free of current.

Frequently Asked Questions

1.What is DS200TBQAG1ABB?

DS200TBOAG1ABB is an Analog termination board under Mark V series.

2.How many Terminal blocks and connectors are included in DS200TBQAG1ABB?

The GE RST Terminal Board Ds200TBQAG1ABB has two 90-pin terminal blocks that can support up to 180 signal lines.The terminal blocks are designated by the letters TB1 and TB2. The GE RST Terminal Board DS200TBOAG1ABB likewise has three 20-pin connectors.

3.How to obtain DS200TBQAG1ABB?

Call or mail john. We provides DS200TBOAG1ABB boards and other turbine control components.